For fitting in control unit cover.
Emergency stop, diameter 22 mm, complete. Emergency stop has been changed to Ø22 early 2004. Ø16 can be replaced by drilling up the hole in the lid.
Emergency stop, diameter 16 mm, complete
BECKER BK1, BK2, BK3, BF6. For Becker motor where end stop is pulled by toothed belt
BECKER BK1, BK2, BK3, BF6. For Becker motor where end stop is pulled by toothed belt
BECKER BK1, BK2, BK3, BF6. For Becker motor where end stop is pulled by toothed belt
Also for BF6 & BF7 motors. For Becker motor where end stop is pulled by toothed belt
3 x 400 V. Mounted between limit switch print and motor cable, to prevent 400V from coming down on limit switch print. Usually used if there has been a short circuit in print and you do not want to replace the motor
For basic PCB with 8 DIP switches.
Programme EPROM with the latest version.
Programme EPROM with the latest version.
For motor without brake. Print with end stop for Becker gear motor with hollow shaft in aluminum
For motor with brake. Print with end stop for Becker gear motor with hollow shaft in steel and click cover. Cannot be used for older type with screwable lid
EHB Basic PCB frequence control FO. 1 x 230 V. (Fits FO1/FO2)
Lid for end stop housing for BECKER motor with release clutch. BF typs with srewable lid.
For gear with steel hollow shaft. Cover of cable connections. Lid to be screwed on. Has changed mid-2005
For gear with steel hollow shaft. Cover of cable connections. Lid to be screwed on. Has changed mid-2005
Type EO1, Ø8 mm, 150 mm cabel. Type EO1, ø 8mm, 150mm cord. Used to switch on / off auto-close
For emergency chain drive. Also used for replacement air controls type BA2 in combination with Lindab EHLDB and EHLDC controls
Chain house for BECKER with emergency chain. Excl. Chain.
L = 4 m. Cable with plug at the motor end
Type BK5, 110 Nm, 30 rpm. * Discontinued - sold as long as stocks last * A110ME/30LK with mechanical end stop. For Lindab EHLDB control
With 2 m, cable. Electric box with the possibility of connecting different equipment to the two additional end stops found in the Becker gear motor
L = 10 m. Cable with connectors on both ends
.JPG?v=108878356)
For door with 5/4" shaft.
Consists of DW hose, 2 x hose connector, 2 x lock ring for 5/4" shaft, cable clamps, screws, pop rivets and cable ties
Consists of DW hose, 2 x hose connector, 2 x lock ring for 5/4" shaft, cable clamps, screws, pop rivets and cable ties
For door with 1" shaft.
Consists of DW hose, 2 x hose connector, 2 x lock ring for 1" shaft, cable clamps, screws, pop rivets and cable ties
Consists of DW hose, 2 x hose connector, 2 x lock ring for 1" shaft, cable clamps, screws, pop rivets and cable ties
For LS1 light control unit, 12 V /. Print for LS1 lamp control. 2 outputs, max load 12V / 20VA. DIP for selecting function
3 non-energised outputs. Type UDM1. Door open signal, door closed and photo or error. Requires that 9-pole socket in control is available