Type BK5, 110 Nm, 30 rpm. * Discontinued - sold as long as stocks last * A110ME/30LK with mechanical end stop. For Lindab EHLDB control
With 2 m, cable. Electric box with the possibility of connecting different equipment to the two additional end stops found in the Becker gear motor
L = 10 m. Cable with connectors on both ends
.JPG?v=108878356)
For door with 5/4" shaft.
Consists of DW hose, 2 x hose connector, 2 x lock ring for 5/4" shaft, cable clamps, screws, pop rivets and cable ties
Consists of DW hose, 2 x hose connector, 2 x lock ring for 5/4" shaft, cable clamps, screws, pop rivets and cable ties
For door with 1" shaft.
Consists of DW hose, 2 x hose connector, 2 x lock ring for 1" shaft, cable clamps, screws, pop rivets and cable ties
Consists of DW hose, 2 x hose connector, 2 x lock ring for 1" shaft, cable clamps, screws, pop rivets and cable ties
For LS1 light control unit, 12 V /. Print for LS1 lamp control. 2 outputs, max load 12V / 20VA. DIP for selecting function
Fitted in control unit cover. Communication print between lamp control and EHLDC
3 non-energised outputs. Type UDM1. Door open signal, door closed and photo or error. Requires that 9-pole socket in control is available
Support with snap for photocell. LP drawing no. 010.02.106-04
10 x 30 mm, for installation of pos.
Magnetswitch for building passdoor with magnet.
NOTE - The lock does not fit on 3 "rails and low lift rails .
Communication cable for lamp control with socket and plug.
For LS1 light control unit.
For LS1 light control unit.
Type LS1, complete with two outlets. Lamp control for EHLDB and EHLDC control. Max load 12V / 20VA. DIP for selecting function. Including wall bracket and communication cable. For use with EHLDC, communication prints must be installed in the EHLDC control cover
Incl. PCB for EHC cover. LS1 lamp control. 2 outputs, max load 12V / 20VA. DIP for selecting function
.jpg?v=120373499)
Lid for control box for light control EHB
For LS1 light control.
For LS1 light control.
230 V 3 W E14 LED IP65.
.JPG?v=108876711)
With 25 m cable.
Photocell transmitter, snap with 25 meter cable. SMT 3000HC S30 25 ICS- 0466163503
Photocell transmitter, snap with 15 meter cable. SMT 3000HC S30 15 ICS- 0466163502
Photocell receiver, snap with 5 meter cabel. SMR 3206 S30 5 ICS- 0466164202
With 5/25 m cable. Photocell system with snap.
5 set pr colli
5 set pr colli
With 5/15 m cable. Photocell system with snap.
5 sets per colli
5 sets per colli
Does not fit on 3 ”rails and low lift rails.
.jpg?v=108856415)
Includes power supply, Ruko cylinder and fittings. The lock does not fit on 3 ”rails and low lift rails.